Creeper Joint Drive Shaft U-Joints
Trail-Gear now offers the strongest U-Joint on the market. We took the stock U-joint and kicked it up a notch by adding additional material to center of the joint. The Creeper JointTM has been tested to 4,700 ft-lbs of torque in our axle testing machine. These U-joints fit most 1979-1995 4wd applications. Includes four install clips and and Zerk grease fitting (not shown in photo).
|
TRG1000651 | U-joint, Creeper Joint | $ 45.00 Each | |
Heavy Duty Replacement U-Joint

|
TRG1000481 | Replacement U-joint, Toyota | $ 22.50 Each | |
10" Long Spline Drive Shaft Kit
Our drive shaft kits are also stronger than stock. Our testing shows that a stock drive shaft will twist off and fail at after a maximum load of 3,900 ft/lbs of torque is applied. Our shaft kits test to a maximum of 4800 ft/lbs or torque. This is accomplished in two ways; first we increase the size of the material both on the inside and outside of the slider section. Then we specially heat-treat the material to increase its strength.
Each kit comes with a Heavy Duty U-joint installed. Full circle retaining rings are installed to securely hold the u-joint in place.
This product is a heavy duty replacement part and is not recommended for applications requiring a balanced driveshaft. Not recommended for use on the street or speeds over 50mph.
|
TRG1000071KIT | Driveline Kit, Long Travel, w/Creeper Joint | $ 238.80 Each | |
|
TRG1000051KIT | Driveline Kit, Long Travel | $ 201.38 Each | |







